ZR10926 16″ Chain Saw

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

The recommended fuel mixture is a 50-to-1 ratio of unleaded gasoline and two-cycle engine oil, and the manufacturer recommends the use of a two-cycle oil that contains fuel stabilizer to keep the mixture fresh if you are not using it immediately.
The year 1963 saw the introduction of the world`s first “lightweight” chainsaw, the magnesium-alloy framed Homelite XL-12; the numeral twelve denoting that the power-head weighed a mere twelve pounds. This saw is widely regarded as one of the most recognizable and well-known chainsaws of all time.
The engine in the Homelite XL Chain Saw displaces 58.2 cc and has one cylinder. The bore is 1.8 inches and the stroke is 1.4 inches.
Help protect your 2-Cycle gas outdoor power equipment with the Homelite 2-Cycle oil. This oil is a 50:1 gas-to-oil ratio.
The fuel and oil mixture should always be 2% (50:1).
This chainsaw model requires a 25 thousandths of an inch gap. Now thread the plug into the cylinder. Be careful not to over tighten.
Features. Be ready for all everyday sawing jobs with the Homelite 37cc 2 Stroke 40cm Chainsaw. The 2-stroke 37cc engine is tough enough to handle all branches, firewood, and other common sawing applications. The lightweight construction makes it ideal to use around the workshop, garden, and on campsites.
If your manufacturer recommends a 50:1 fuel/oil mix, it means you need 50 parts of gas to one part two-stroke oil. To mix one gallon of fuel at 50:1, add 2.6 ounces of two-stroke oil to one gallon of gas, as shown in the chart below.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

I need the fuel line size on Homelite gas blower. Is the fuel filter a washable/cleanable filter?
ANSWER : I think they are 1/8 in hoses on them and if it is a foam filter they are washable,mild soap and then a light coating of oil

Read Full Q/A … : ZR10926 16″ Chain Saw

Need fuel diagram – Stihl Fs36 Line Trimmer Gas Tank
ANSWER : Http://www.mediafire.com/view/yleara73l4w78xa

Read Full Q/A … : ZR10926 16″ Chain Saw

Got a homelite ut 15039a (weedwacker with blade st 185)
ANSWER : You have the rong fuel tank for that model.Thats the return pipe its comming from so you can drill a hole if youwant but make sure its sealed properly.

Read Full Q/A … : ZR10926 16″ Chain Saw

Where can I get a fuel line routing diagram? – Husqvarna 28cc Hand Held Blower HVH 125B
ANSWER : Just go from the fuel tank straight to the carb and the primer. The pipes are a set length so you don’t have to worry about threading it all around the blower.. just take the most direct route from the tank to the carb..!

Read Full Q/A … : ZR10926 16″ Chain Saw

Need diagram for fuel line in tank fuel filter
ANSWER : The small diameter fuel line that has the fuel filter in the tank on it goes directly to the carburetor (with the built-in primer or externally mounted primer). IF the carb has the external primer, the small line goes to the nipple on the carburetor opposite the end with the hole in the cover. If it has the built-in primer on it, it goes to the carb body on the nipple furthest from the bulb. The large diameter line is the fuel return line and if the carb has the bulb on it, this line connects on the nipple closest to primer bulb.. With the externally mounted primer, this line connects on the longest nipple coming out of the primer and goes to the fuel tank (not the filter though). There is a nylon connector inside the tank that holds this larger line in place. The shorter nipple on primer bulb has a smaller diameter fuel line connected to it and connects to the nipple on the carb closest to the end with the hole in the cover. Built in primer has 2 fuel lines…externally mounted has 3.

Read Full Q/A … : ZR10926 16″ Chain Saw

Fuel line diagram – Poulan P3314 14-Inch 33cc 2-Cycle Gas-Powered Chain Saw
ANSWER : Here is the way to hook up the fuel lines

Note: I put it together outside of the saw so you could see how it is hooked up. Fuel filter/pickup >>to>> Inlet on carb >>to>> Outlet of carb >>to>> to inlet on Primer bulb(shorter post) >>to>> Outlet of primer(longer post) >>to>>Fuel tank (usually has a retainer in tank to prevent fuel line from coming out.)

Read Full Q/A … : ZR10926 16″ Chain Saw

My Homelite Mighty Lite has developed perished fuel lines. (12 months after purchase!!!!!!) Is it possible to obtain spare fuel line…. preferably attached to a new fuel tank as well. It looks like a really hard task to change only the lines.

Many thanks.

John

ANSWER : The fuel lines can be purchased separately usually by the foot from any outdoor power equipment dealer. They can be easily installed by cutting one end at an angle and “feeding” it through holes. Homelite fuel lines are of a different OD than most so make sure you get the proper size. The most popular size for Homelite is OD .203 ID .04.

Read Full Q/A … : ZR10926 16″ Chain Saw

Replaced fuel lines and pressing the primer pump does not feed gasoline to the car.
ANSWER : Sounds like you have the fuel lines switched around. The fuel line closest to the primer bulb will be the shortest line. It only goes 1″ or so into the tank. The other line will be the longest line, and sometimes the smallest in diameter of the two depending on the size of your trimmer, and must rest comfortably on the bottom of the tank.Jim

Read Full Q/A … : ZR10926 16″ Chain Saw