30″ Double Sided 24cc Hedge Trimmer

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

The air filter may be clogged or dirty. If the air filter is clogged, the engine will get too much fuel and not enough air. As a result, the engine may not start. If the air filter is clogged, replace it.
If your engine runs, but the trimmer blades do not move when the throttle is engaged, the clutch may be broken or improperly tensioned. The clutch is attached to the crankshaft, and engages the gearbox to start rotating once a certain rotational speed is reached.
The first thing to do is to ensure that the battery is fully charged. If after charging the battery you are still experiencing the problem, then it may indicate a fault with either the battery or charger. The defective item will need to be replaced.
If your trimmer won`t turn on, especially if it has not been used recently, you may simply have a drained battery. Plug your trimmer into your charger and see if anything happens. Ideally your trimmer will recognize it has been connected to a power source and charge its battery.
over time the arrestor can become clogged with soot which may cause the trimmer engine to stall. you can try cleaning the arrestor with a wire brush. but you may need to replace it with a new.
The clutch engages the clutch pads to spin the trimmer head. If the clutch assembly is defective, the clutch will not disengage the clutch pads, and the trimmer head will continue to spin, even at low speeds. If the clutch is defective, replace it. (Note: some string trimmers do not have a clutch.
Use Tanaka two-cycle oil or a quality two-cycle oil at mixing ratio of 25-50:1 (Gasoline (A) : Oil (B)), only for the state of California at 50:1. Never use multi-grade oil (10 W/30) or waste oil. Always mix fuel and oil in a separate clean container.
About Tanaka Power Equipment Tanaka Power Equipment is a Brand within the Hitachi Power Tool Group. Tanaka`s innovative product line provides landscapers, property managers and utility professionals with two-stroke commercial grade outdoor power equipment solutions.
In 1985, Tanaka relocated its entire operation to a new 70,000 sq. ft. facility in Bothell, WA.
With a severed cord, your hedge trimmer is virtually worthless. With a small amount of money and a little ingenuity, however, you can repair the cord and have the trimmer running. If the cord left attached to the trimmer is long enough to be useable, then you simply can add a new plug to its end.
The powerful motor provides 3,000 strokes per minute for efficient, effortless trimming. Enjoy up to 35 minutes of runtime with the included 18V ONE+ 1.5Ah lithium battery. Easily tackle difficult hedges, bushes and shrubs with 22” blades and a 3/4” cut capacity.
If your 2-stroke brushcutter fails to start, the simplest explanation is that there is not enough fuel: in this case you simply need to top it up. A 2-stroke brushcutter engine runs on fuel/oil mixture, which you can buy ready prepared, such as EFCO-Mix Alkilate alkylated mixture in a 5 L can.
The most common problem with a string trimmer is that the unit runs out of string. The string may also be twisted or loose on the spool. The cutting head may be dirty or the head outlet guide may be bent. An electric trimmer`s power cord, switch, or motor may fail.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

I have a Tanaka hedge trimmer and it has developed the following fault. If I hold the trimmer with the blades pointing upwards the engine runs okay but when I lower the blades to the horizontal position it loses power. When the blades are pointing to the ground the engine cuts out.
ANSWER : Does this happen when the gas tank if completely full? If this only happens when the gas tank gets a little emptier than full, I think I know what the problem is. There are two hoses which run from the gas tank to the carb. One of the hoses is attached inside the gas tank to the “bottom” of the tank. The other one is just inside the tank. These two hoses have to create the correct liquid air combination in order to ciphon the gas out of the tank, hence no fuel pump. The primer button starts the ciphon at initial start-up. The problem is either your hoses or your primer button.

Blades wont move when power connected. Stripped it down. Motor is fine. I think it must be the gears attached to the blade unit
ANSWER : Either the gears, OR SOME machines have a “CENTRIFUGAL CLUTCH” [a safety feature] between the engine and the blades.

IF your machine has this feature, then it’s possible that the clutch has worn out and is slipping so badly that the blade won’t move.

Not cutting properly. blades seem to be out of sync.
try to spray oil the blades
if not helping
take the machine to be seviced you might need to sharpen the blades.

Engine runs great, accelerator responds perfectly, but the blades stopped moving. Any ideas?
ANSWER : Ensure blades are sharpened. If there are burs on blades they can seize.Blades should be lubricated with WD40 , waste oil or other lubricant.The bolts holding the two blades together shouldn’t be too tight.

Ryobi TP30 straight shaft line trimmer convertible – drive shaft disconnected from motor
ANSWER : Check both ends of shaft, they’re usually a hex or torx head. sometimes the can strip or even snap off. if you find noticable damage replace the shaft

Blade moves back and forth,but won’t cut anything
ANSWER : Check the bolts or screws holding the blades together are tight but not so tight that they cant move. Ensure blades are sharp.

How do you sharpen the hedge trimmer. It is the homelite handy hedge 2.7 17 inch blade

I have a tanaka tht 210b trimmer and the blades are gone loose at the engine side. A guy said there might be something broken on shaft.