Chain Saw 20″ Bar

Hi,
I was wondering how much oil and gas a typical Husqvarna chainsaw fits in its tank. And how many tanks do you generallu need to fell down a Pine or Western Hemlock of average size.
Experienced gardeners share their insights in answering this question :
Under normal working condition the saw is designed to run for approx 25/30 minutes

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Most chainsaws are designed to use up a full tank of bar and chain oil for every full tank of gas.
Oregon Chainsaw chain for Stihl Chainsaw 20″ Bar Length 72 Drive links 3/8 Standard 0.05 Gauge.
All STIHL gasoline-powered equipment uses a 50:1 gas and oil mixture.
NO, outboard two stroke motor oil designed for water cooled engines does not provide the needed protection or lubrication for two stroke air cooled engines.
The fuel and oil mixture should always be 2% (50:1).

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Do I need gas and oil mix – Poulan Super 250a Chainsaw Plate
ANSWER : I think Poulan uses a 40:1 ratio to one gallon of gas, however I have always used 50:1 the same as my sthl saws with no issue. I would rather have more oil mix that to little.

Read Full Q/A … : Chain Saw 20″ Bar

Do you mix gas and oil in this trimmer – Ryobi 30 Cubic Centimeter Curved Shaft Gas Trimmer
ANSWER : Yes. Verifythe ratio, either 40:1 or 50:1

Read Full Q/A … : Chain Saw 20″ Bar

Gas to oil mixture for a RY 26540 – Ryobi 30 Cubic Centimeter Curved Shaft Gas Trimmer
ANSWER : 50:1 don’t use outboard motor mix

Read Full Q/A … : Chain Saw 20″ Bar

Need gas mix solution – Craftsman 25cc 2-Cycle Gas Blower/Vac
ANSWER : Check age of gas. Cannot be more than 30 days old.

Make sure to use fresh gas w/synthetic 2-cycle oil @ 40:1 ratio
(1 gal.) Gas to 3.2 oz. Oil).Do not use old or stale oil/gas mixture. Always
use the proper oil/gas mix. If you do not, your engine will suffer rapid,
permanent damage.

Read Full Q/A … : Chain Saw 20″ Bar

I need the gas mix oil ratio for the Poluan Pro 42…
ANSWER : 40:1 gas to oil ratio.

Read Full Q/A … : Chain Saw 20″ Bar

How do u mix the 50/1 ratio oil and gas mixture
ANSWER : Mix 2 1/2 oz of 2 cycle oil into 1 gal of gas

Read Full Q/A … : Chain Saw 20″ Bar

What is the oil and gas mixture ratio for a gas powered leaf blower?
ANSWER : Per http://www.echo-usa.com/faqs/ it 50:1, there is a chart at the site that shows how to mix it.

Read Full Q/A … : Chain Saw 20″ Bar

Is it straight gas or mixed? – Poulan Pro 14" Gas Chainsaw 33CC P3314
ANSWER : It uses a gas/oil mix. 40:1Hope this helps.

Read Full Q/A … : Chain Saw 20″ Bar