How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Look to ensure the saw is plugged in properly, and check for a blown fuse or tripped circuit breaker if the saw won`t start. Replace the brushes by removing the motor end cap and lifting the brush spring to withdraw the brush assembly. Replace with new brushes in the reverse order as they came out.
Affected Models

The DeWalt miter saw recall affects the following models which include two corded and one battery-powered FlexVolt saw: DWS779. DWS780 12-inch miter saw. DHS790 FlexVolt 40V miter saw (including designations DHS790AB and DHS790AT2)

Replace the motor brass:

If you`ve tried everything and your circular saw still won`t cut wood, the issue is most likely due to a damaged engine brass screw. Your circular saw`s motor is held together by a brass screw, and if it`s missing or broken, your circular saw may stop working in the middle of a job.

A failed power supply, broken on/off switch, bad motor overload, broken power cord or failed drive motor can prevent the table saw motor from starting. First, try resetting the overload. If the table saw motor won`t start after resetting the overload, then the saw may not be getting power from the electrical outlet.
If the motor is spinning, but the blade is not, the first thing to check is the belt as they wear out and break. You can inspect the belt by removing the belt cover. If the belt is broken, remove it and install a new one. On some models, you will have to walk the belt onto the pulleys.
Over time, the brake can lose its effectiveness as a result of a dirty commutator, a failing armature, or a bad switch. But there`s a good chance the solution is even simpler: Replace the motor brushes (less than $20).
There are several reasons your miter saw may not be cutting straight. The blade is warped, damaged, or not installed correctly. The bevel gauge on the miter saw is misaligned. The miter gauge is misaligned.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Have a remington electric pole saw with a short inside the pole,is this fixable and where can I get it fixed?

Read Full Q/A … : Garden

I am in the need of the attachmnent for the

Read Full Q/A … : Garden

Where do I buy Pole saw parts – Remington Electric Pole Saw
ANSWER : Call 1-800-654-8534

Read Full Q/A … : Garden

I have Remington REM55PV heater. It starts just fine but when I take finger off ignition button, heater won’t stay running.

Read Full Q/A … : Garden

Cannot locate parts dealer for electric Remington Limb n Trim 10 chain saw. I require pan head shoulder screw . I live in Alberta, Canada (Devon town near Edmonton)
ANSWER : Here’s a good place to look!

Read Full Q/A … : Garden

Lost oil cap and bulb
ANSWER : Remmington’s parts department.

Read Full Q/A … : Garden

I need to replace just the saw portion the pole is good?
ANSWER : If you want to check for replacement parts, there is a supplier that carries most parts for the Remington electric chainsaws and the pole saws.

They also sell new ones, so you could buy just the chainsaw for the pole saw, if you wish.

Here’s their web site for both replacement parts and new chainsaw products for the Remington line.

Hope you find this Very Helpful and best regards!

Read Full Q/A … : Garden

I have a remington pole saw and I need to know where to buy the 10 inch chain. It says 10″ bar chain 097567-01 chain 091371S.Home depot or Lowes don’t care. Zip code 33328 Ft lauderdale
ANSWER : What Jerr isn’t telling you is the link is worthless. RemingtonPower is no longer in business. SorryLou

Read Full Q/A … : Garden