Garden
Experienced gardeners share their insights in answering this question :
Your governor has failed and unless you get repaired itwill eventually throw a rod out the side of block
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die
By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.
If your trimmer engine idles, but stalls on throttle, check the following parts: the gasket, primer bulb, fuel filter, air filter, fuel vent, fuel line, and carburetor. The repair and symptom guide will help you better identify the part needed to be replaced and how.
The fuel line may be clogged from stale fuel deposits, more reasons to cause your chainsaw to cut out when applying throttle. If a fuel line is cracked, it will leak gasoline and draw air from outside into the fuel line. If the line is leaking fuel, it needs to be replaced.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
As the fuel level drops, a vacuum begins to form in the fuel tank because air can get in to fill the space the consumed fuel occupied. After about 10 or 15 minutes, the vacuum will become strong enough that fuel will stop flowing to the carburetor and the lawnmower will die.
A clogged carburetor is most commonly caused by leaving fuel in the string trimmer for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
When your trimmer starts and runs on choke, it could be because the check valve in the gas cap is clogged. Start the trimmer and gently unscrew the gas cap halfway off. Turn the choke off and assess. If the engine is still running, that means the gas cap may be the culprit.
The carburetor might be clogged. A clogged carburetor is often caused by leaving fuel in the chainsaw for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the chainsaw engine to stall.
If your chainsaw still starts and then stops working, check the air filter. Clean or replace the air filter if it is dirty or damaged. Another reason that your chainsaw starts and then stops working could be that the spark arrestor is dirty or clogged. If this is the case, clean it with a wire brush.
A full gas tank and oil reservoir are the essential first steps when checking why the lawn mower won`t stay running, but the problem could also be a dirty filter, clogged carburetor, improper fuel mixture, or a dirty spark plug.
If your lawn mower starts, runs briefly, then dies these are the four most common reasons that`s happening: Dirty carburetor / clogged carburetor bowl. Old gasoline that has gone bad. Dirty or defective spark plugs.
The most common cause of a mower that runs for thirty minutes and then dies is a faulty armature. A faulty gas cap is the second most likely cause.
If the engine will idle but dies at full throttle the main jet in the carburetor may be plugged. You can repair a plugged main jet by cleaning it, replacing the jet, or replacing the carburetor. If you choose to clean or replace the main jet, you will also want to clean the rest of the carburetor.
If the engine will idle but dies at full throttle the main jet in the carburetor may be plugged. You can repair a plugged main jet by cleaning it, replacing the jet, or replacing the carburetor. If you choose to clean or replace the main jet, you will also want to clean the rest of the carburetor.
Use Carburetor Cleaner
Fortunately, you can generally do this without even taking the carburetor out of the engine. Start by purchasing some commercial lawnmower carburetor cleanerOpens a new window, which comes in a simple spray can and will make it easy to clean the inside and outside of the carb.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Weed eater starts but won't stay running – Weedeater 19 in 25cc Gas Hedge Trimmer
ANSWER : Probably “gum” and “varnish” build-up clogging the TINY passages [called ‘galleries”] inside the carb!
Read Full Q/A … : Garden
Engin runs fine at idle but stalls out at high idle and wont rev up.
ANSWER : Hi 5flash… Get an assistant and a can of starter fluid. Remove the air cleaner and spray some starter fluid into the air intake. Start it up and spray the starter fluid as you move it to high idle, repeat until it works properly. Joe
Thanks for choosing Fixya!
Read Full Q/A … : Garden
Will only start and run in choked position, when throttle applied chokes out. If started with out choke and throttle position in low speed will start and run for 10 sec then like it runs out of gas.
ANSWER : I have your solution guaranteed, I fixed mine yesturday remove H L screw plastic caps and on high 11 threads exposed and on the low side 8 threads exposed. removing the plastic caps allows u further adjusting these wear out or move soo just take them things off and you will be rolling
Read Full Q/A … : Garden
Does not run, will start with starting fluid – Mantis 2-Cycle Tiller
ANSWER : You should never use starting fluid on this model.
Add a couple of ounces of 100% acetone (available at Walmart) to some fresh fuel. Attempt to start for several pulls. Let sit for several minutes and repeat until it sounds like it wants to run.
Then watch this video and do it:
http://www.alamia.us/mantis_parts_s/148.htm
Read Full Q/A … : Garden
Poulan blower was running – ran out of gas – put gas in – won’t start- primed – won’t start – let sit – won’t start-took cover off – sprayed starter fluid in carb – won’t start- -(very little stutter) won’t start-set overnight – repea -twon’t start-wits end !!!
ANSWER : Hello
Does it use a fuel and oil mixture?You probably did that.
Does it use a fuel and oil mixture?You probably did that.
Try removing the spark plug and cleaning it with a wire brush or some emery cloth.Make sure you have spark by connecting the plug wire and resting the plug on the metal motor block.
Do not hold the plug in your hand ,if you have no spark you may have a bad magneto.
Read Full Q/A … : Garden
I forgot to add oil to my toro ccr powerlite e. should i remove the gas and start all over again?
ANSWER : !!!!!! dran the gas put in the neww mix gas and pray for the best
Read Full Q/A … : Garden
My tractor stalls like it is starved for gas although the gas tank is full. I,ve changed the fuel filter and the gas cap. I’ve cleaned out the gas tank, gas lines, and the carburetor bowl. The problem seems more acute when the gas tank is full or near full. At this time to alleviate the problem, I blow through the gas cap and the fuel filter fills with gas and it runs good again. But as soon as the fuel filter has no more gas, of course, it stalls until I blow on the gas cap. As the tank gets down to about 1/3 full, the engine runs OK. What else could cause this condition?
ANSWER : I had a similar problem with a sears tractor. close to the carbarator is a rectangle box with a rubber hose going to the engine block – remove the hose and spray carb cleaner in the hose wait a few mins and try again – its a vacuum for the carb
Read Full Q/A … : Garden
Will not start. changed to a new plug. Plug does have a spark. Seems to be getting gas as the more I pull the rope the more gas collects in the cylindar. Last spring I loaned it to a friend. Last summer I ran it briefly & it was idling extremely fast. I changed the gas before I tried to start it. Could the idle be messed up ? Idle Screw What is the approximate counter clockwise turns to get the idle in the “ballpark” to run ?
ANSWER : Better check friend might not have added oil to gas and it scored the cylinder wall
Read Full Q/A … : Garden
