PYT 9000 26 HP 48″ Yard Tractor

Experienced gardeners share their insights in answering this question :
The first thing to check for is that the drive belt is not broken. Sometimes they’ll snap, but stay attached hanging to the flywheels, so you won’t see them in the yard. Of course, if this model is shaft-drive, disregard the above advice. That’s about all I can tell you, but my guess is a broken drive belt. If the drive belt’s OK, I have no idea what your problem is.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

If the PTO clutch is not getting power, if the clutch solenoid is defective, or if the clutch is worn out, the lawn mower blades will not engage. The PTO clutch is not repairable—if the clutch is defective, you must replace it.
If the PTO clutch is not receiving power, the clutch solenoid is defective, or the clutch itself is worn out, the blades will not engage. Since a PTO clutch is not repairable, you will need to replace a broken or worn out clutch with a new one.
There are several reasons a Craftsman lawnmower may turn over but not start, with the most common ones including the following: Lack of fuel. Dirty air filters. Electrical issues in the ignition system or the starter motor.
If the PTO clutch is not getting power, if the clutch solenoid is defective, or if the clutch is worn out, the lawn mower blades will not engage. The PTO clutch is not repairable—if the clutch is defective, you must replace it.
Your lawn mower turning over but not starting due to several reasons, such as a faulty or disconnected plug, a disconnected spark plug wire, a clogged air filter, or a contaminated fuel tank. A faulty carburetor, a dirty cutting deck, or a dysfunctional flywheel brake can also cause this.
PTO clutches generally overheat because of improper lubrication/greasing (both too much and too little can cause problems), excessive sideload, or a new installation. Operators are advised to reduce sideload and inspect grease levels first.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Will any other engine fit a craftsmen 26 hp lawn tractor other than the kohler
ANSWER : Yes there are 2 other options.
Briggs and Stratton, and Onan.
Here is the information. You will need to have your output shaft size.

http://www.smallenginewarehouse.com/

Read Full Q/A … : PYT 9000 26 HP 48″ Yard Tractor

I need a operating maual for a craftsman riding mower 28990
ANSWER : Sears Manage My Life has the Operator’s Manual: . Click on “Craftsman Lawn, Tractor” to get to the manual page.

Read Full Q/A … : PYT 9000 26 HP 48″ Yard Tractor

Can’t get front wheel back on lawn tractor
ANSWER : Grease your shaft and make sure you have no dirt on it, even dust can hinder getting it on right.

Read Full Q/A … : PYT 9000 26 HP 48″ Yard Tractor

Engine will not engage into drive – Craftsman PYT 9000 26 HP 48" Yard Tractor
ANSWER : The first thing to check for is that the drive belt is not broken. Sometimes they’ll snap, but stay attached hanging to the flywheels, so you won’t see them in the yard. Of course, if this model is shaft-drive, disregard the above advice. That’s about all I can tell you, but my guess is a broken drive belt. If the drive belt’s OK, I have no idea what your problem is.

Read Full Q/A … : PYT 9000 26 HP 48″ Yard Tractor

My craftsman dys 4500 26hp 54 – Craftsman 26 hp 54 in. Deck Deluxe Yard Tractor – CA Model
ANSWER : Whats the problem?

Read Full Q/A … : PYT 9000 26 HP 48″ Yard Tractor

My Garden Tractor will not start. It turns over but does not attempt to start. The Battery is less than sis months old.
ANSWER : Change fuel filter

Read Full Q/A … : PYT 9000 26 HP 48″ Yard Tractor

Have a Craftsman 26 hp, 48″ mower…mower starts runs but when I try to engage the blades nothing happens. Checked all the belts, ck for blockage but nothing…what would the next step be?? Tks
ANSWER : When you say nothing happens…is the PTO engaging? You said that you already checked the belts…if none of these are off…you maybe looking at a new PTO clutch.www.nnyparts.com

Read Full Q/A … : PYT 9000 26 HP 48″ Yard Tractor

I have problem with pulles an my craftsman 17 hp 42in
ANSWER : YOU MUST USE SEARS BELTS ! THERE A ODD SIZE

Read Full Q/A … : PYT 9000 26 HP 48″ Yard Tractor

My name is June Strandberg, and I am a florist and gardener in San Francisco. I have been working in the industry for five years, and I love helping people find the perfect floral arrangement for their special occasions. I am also skilled in troubleshooting and fixing gardening tools, so if you are ever having trouble with your tools, please don't hesitate to reach out to me.