Husqvarna
Experienced gardeners share their insights in answering this question :
Poss saftey interlock switch failure. Bad ign coil or the harness has shorted to ground Unplug the kill wire from the coil and if fire “spark” returns then u know your coil is good. Hope this helps
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
If you pull the cord and hear your engine turn over, but your mower is not starting, the most common reasons for this are low fuel, a broken gas valve, or a bad choke fault. A broker spark plug could also be the culprit. You may also have to change the fuel pump if it does not get fuel to the ignition system.
If no spark appears, check for broken wires, shorts, grounds or a defective stop switch. Once you have confirmed that the stop switch is working, reconnect the spark plug lead.
If it is difficult to start the ride-on mower, the most common reasons include: Old fuel; make sure to use fresh fuel, especially after winter storage. Spark plugs might be dirty or damaged. How to examine and replace a spark plug on your ride-on mower.
Examine the spark plug
A dirty or fouled spark plug can cause your lawn mower to not start. It can also work itself loose, causing issues. If the spark plug appears to be seated correctly but the engine doesn`t start, a new one may be in order. For a few dollars, this easy fix can get your small engine working again.
If your tractor cranks, but won`t start, you`ll want to look at a few different engine components. Is the fuel making it to the cylinder? Check the fuel level, the shutoff valve, and the fuel filter. If those components look ok, air might not be making it to the cylinder.
Disconnected, dirty or fouled spark plugs are common causes for engines that won`t start. For small engines, spark plugs typically need to be replaced every season or after 25 hours of use. You should also check to make sure the spark plug gap is set correctly.
You should see a strong spark between the tester`s terminals when the engine is cranking. If there is no spark, this indicates that the spark plug is defective and should be replaced. Need help finding your model number? The carburetor might be clogged.
Dirty/Clogged Air Filter If the air filter becomes too clogged with dirt or dust, there may not be sufficient air reaching the cylinder. This can cause the fuel to not burn, and the engine will not start as a result. If upon visual inspection the filter appears dirty or dusty, follow our Air Filter Replacement Guide.
Disconnected, dirty or fouled spark plugs are common causes for engines that won`t start. Spark plugs typically need to be replaced every season or 25 hours of use. You should also check that the spark plug gap is set properly.
If a mower is hard to start, it may be the result of a dirty carburetor and/or a clogged air filter. Use a screwdriver to remove the carburetor and clean any dirt out of it with a rag. Clean the air filter or replace it if it`s disposable.
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
My Z5426 won’t start. When I pull out the choke and turn the key, gas starts leaking out of the exhaust system just before it gets to the muffler. Last time it did start, it ran really rough. So, I turn off the engine and then tried to restart and that’s when I noticed the fuel leak.
ANSWER : Maybe bad fuel, fuel line leaking, flooding of the carburetor, since it did start and ran rough I am assuming that the gas was left set and more then likely this gummed up the carburetor, you will have to clean/rebuild it. If you have a can of carburetor clean you may be able to spray that into there and clean it up, I would not choke it to start it as it sounds like it got/is flooded/ing. Good Luck Tim
Toro clear won't start – Toro Power Clear 621 R
ANSWER : Bad gas , plug ,air filter , no spark ck all need all 3 to start
Toro 149cc Lawn Mower Won't Start – Toro Lawn Mower With Toro Power Tools
ANSWER : Bad carburetor your old fuel jammed up the jet so it won’t get fuel and if it does it will start and shut off So replace the carb or try to clean the jet and run non oxy fuel only
Honda gx200The water blaster just stopped and I change the spark plug but still only a very small spark that is when it sparks?Coil buggered?
ANSWER : Very small spark okay as long as its blue and not bright yellow.try using starting fluid if runs might want to see if carburetor is getting fuel.
Mower won’t start
ANSWER : This may sound stupid but don’t mean it to…
Have you tried with the choke all the way open? Do you have an automatic cruise? Is the right (correct) pedal being pushed in? These will affect if it starts or not. Also if your drive belt or one of the other belts not being tight enough will affect if it starts or just turns over. Not too many things can stope it from starting with new/good battery AND if its getting gas. Try cleaning your gas line and obviously making sure there is no obstruction around or near your blade, if it does start with blade engaged that is :))
If it doesn’t start with blade engaged, well make sure it’s in neutral. Mine won’t start in reverse but will in forward or neutral.
Hope it helps.
Anthony
My mower will start but won't stay running – Toro LX466 22HP Lawn Tractor 13RT61RH244
ANSWER : I am going to respond 2 times to this post. The first reply will be generic things to check.
First off check the oil level and make sure it is serviced to full.
If your having a lack of fuel (runing lean) you will need to check fuel flow at the carb fuel mainfold. It should fill a spray paint can lid in less than 10 seconds but teting flow rated of the main fuel line. If you have poor flow here… you need to check the fuel filter and the fuel tank outlet port for obstructions.
Good Fuel flow still shutting off…. remove the carb float bow and clean the debris from the bow’ and the treaded area where the fuel solenoid mounts Additionally you will have to again remove the main fuel line and spray carb cleaner in the float needle area to flush out any debris through the fuel hose connection.
For the second response I need to know which engine is installed on your mower by MODEL number if you can locate it. (there are 3 engines) At least try to find the engine model number. If you can not locate it Brand and HP of the engine (I assume 22 hp) Thanks for choosing FixYa,
Kelly
My garden tractor husqvarna model no yth1746 kohler engine 17hp won’t start backfires through exhaust and carb. and pushing gas out of muffler.
ANSWER : Take a look at this tip I wrote on the no
start problem. It should help you.
My toro 6.5 hp push mower (2010), has no fire to the plug. I have not abused it. i have a small yard and it just gets normal use. Now it won’t fire. I first changed the fuel and cleaned the carb thinking it was that crappy ethanol again. but i grounded out the spark plug and cranked it…no spark. I think it has to do with the lever you pull back to start it . they have some stupid complicated safety contraption that rides along the fly wheel when you pull back on the handle for starting and shutting off the engine. …it looks worn out already…like a mini brake pad. any ideas?…do i really have to replace this garbage every year or am i on the wrong path here?
ANSWER : Unhook your wire from the coil that goes to shut off mechanism, and see if you have spark then. the wire may be grounded out, or your coil might have took a ****
