Craftsman

Experienced gardeners share their insights in answering this question :
The trans will need to be torn apart and new grease put in it.
Sam

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

The reasons why mower is not moving forward or reverse is that the battery is dead, or due to clogged fuel line. Additionally, malfunctioning transmission, or a broken drive belt, also a faulty spark plug, even when friction wheel isn`t in contact with the friction plate, or damaged Tires.
There may be old or bad fuel in the carburetor float bowl. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and make the engine hard to start. If the carburetor is clogged, try cleaning it with carburetor cleaner.
Failure of any mechanical component, a broken hose, or clogged filter will cause tractor hydrostatic transmission problems. But the most common issue will be the oil itself. In the transmission section of your operator`s manual, you`ll find a section that covers oil viscosity.
One of the disadvantages of hydrostatic drives is that the majority of the oil stays in the loop and doesn`t return to the reservoir for cooling. One way to return some of the oil back to the tank is by using a hot oil shuttle valve.
These control rods are adjustable. By rotating the threaded linkage connector ferrules, the length and the resulting range of movement at the regulator valve can be altered.
They are filled with the specified pump fluid to match each pump design and then sealed by each manufacturer at their factories. Replacing hydrostatic fluid is normally not necessary, unless the drive system is in need of some other internal service or repair.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
The most common cause of a mower that runs for thirty minutes and then dies is a faulty armature. A faulty gas cap is the second most likely cause.
If you attempt to push a tractor with a hydrostatic transmission, it causes fluid to move backward through the pump and can damage the seals. You must disconnect the drive before moving your lawn tractor.
Lawn Mower Turns On But Won`t Move

The most common issues include a broken or damaged belt, a clogged discharge chute, a broken or damaged drive cable, or a damaged or clogged transmission. It`s important to inspect these parts and determine which one is the problem before attempting to fix it.

Check the drive control cable when your lawn mower won`t move because the drive cable can stretch over time. Replace the control cable if it`s damaged. A worn or broken drive belt will also prevent the mower from moving so check the belt next. Adjust the drive belt or replace it if it`s broken.
Riding mower not going forward or reverse could be caused by a number of issues. The most common cause is a stuck or broken clutch, which prevents the mower from moving. Other causes could include a broken or disconnected drive belt, damaged transmission, or a problem with the mower`s starter or ignition system.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

The gears are very hard to shift
ANSWER : You need to put dope in trans and check gear shifter to see if it is loode if not check your drive belt

Read Full Q/A … : Craftsman

Gearshift is stuck,cant change gears what do i do
ANSWER : Is it hydrostatic or manual ?

Read Full Q/A … : Craftsman

Need to add oil in my hydrostatic tranny – Craftsman 42 in. Deck 19.5hp Lawn Tractor
ANSWER : There a plug on top of transaxle.

Read Full Q/A … : Craftsman

Craftsman riding mower lt-1000 leaks gas – Craftsman 17.5 hp 42 in. Deck Lawn Tractor – CA Model
ANSWER : Need to fix that. it may be a fire hazard.

Read Full Q/A … : Craftsman

Clutch wont engage on 80’s model craftsman belt driven mower. When the pedal is depressed the mower will stop but I can smell the belt burning and the gears grind when changing them. I looked under the mower and don’t see any type of clutch mechanism at all. Am I missing something?
ANSWER : SOUNDS LIKE YOUR TRANS IS WORE OUT IT MAY BE A BAD PULLEY

Read Full Q/A … : Craftsman

How do I get my carburator to get gas – Craftsman 42 in. Deck 19.5hp Lawn Tractor
ANSWER : Be sure the wire on bottom of carb, is plug in and switch turn on,

Read Full Q/A … : Craftsman

Fuel lines split hoe to rerplace – Craftsman 4 Cycle Blower/Vac
ANSWER : Hi Rick…Hope this is what your looking forBud

Read Full Q/A … : Craftsman

I need to see a picture of the hoses to the carb, one I know gas. the other one I’m not sure
ANSWER : The other usually goes to the primer bulb

Read Full Q/A … : Craftsman