Lawn Tractor 48″ Deck, 23 Hp, Model# Yth2348

Was cutting grass engine started missing would only run with choke out, then quit,cleaned filter,diconnected fuel filter ,no gas to filter,does this mower have a fuel pump?
Experienced gardeners share their insights in answering this question :
If there is no gas to the filter check the line going to the filter.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
Check the Fuel Filter

To start, tap the side of the carburetor to help the flow of gas. If that doesn`t work, you might have a clogged filter. Not all lawn mowers have a fuel filter, but for the ones that do, it`s usually located in the fuel line or the fuel tank.

Your lawn mower turning over but not starting due to several reasons, such as a faulty or disconnected plug, a disconnected spark plug wire, a clogged air filter, or a contaminated fuel tank. A faulty carburetor, a dirty cutting deck, or a dysfunctional flywheel brake can also cause this.
If the plug is clean or you`ve replaced it and the mower still won`t start, the issue could be a lack of fuel. Either the carburetor is dirty and not able to mist the fuel to be mixed with incoming air, or no gas is getting to it to begin with.
Weak or Corroded Fuel Pump.

If the fuel pump in your car goes bad, gas won`t be able to flow from the tank to the engine, and it simply won`t be able to run on its own. So we`ll simply recommend that you have the pump replaced.

To check fuel delivery, remove the fuel line where it enters the carburetor and use a length of rubber hose to direct the flow into bottle or similar container. Fuel should pulse out in strong spurts if your engine is equipped with a mechanical fuel pump (electric fuel pumps are more of a steady stream).

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

I have a husqvarna 323L string trimmer. I stored it after running the tank & carb dry for about two years. I fueled it, then started it, & it ran for a minute then died like I turned the switch off. Since it would not restart, I found the fuel filter had broken off the hardened fuel line & it sucked gummy crap out of the tank & into the carb. Failing at cleaning the carb, I finally put a new carb on it & replaced the pump, hoses & filter. It has ran good till this year. I winterized it with stabilizer & left it with a full tank over the winter. The gas in the tank was gone when I got ready to use it this year. I filled the tank with premix, checked for leaks, then started it. It would run fine for about half a tank, start idling poorly (lean) then cutoff & refuse to restart till I refilled the tank. I finally found the tank had cracks & was letting pressure out of the tank & apparently this was causing the carb to lose it’s ability to siphon gas out of the tank. So I replaced the tank which came with new hoses & a filter, which I properly installed to the carb. It cranked right up, but when it runs a half tank, the carb quits sucking gas out of the tank. When I pump to prime the carb, it moves the fuel into the carb, but the pump never gets hard like it does when I prime the carb when the motor is cold. I have to keep refilling the tank, prime, & then it starts & runs until the tank gets about half empty. The new fuel filter is down in the gas tank properly, but It will not run after it shuts off until I refill the tank & prime. I’m baffled. New tank, new hoses, new filter, new carb, & I can find no leaks in the fuel system. It runs strong. The 323L is a two-stroke & it always cranks on the second pull from cold on a full tank. Any ideas?

My tractor stalls like it is starved for gas although the gas tank is full. I,ve changed the fuel filter and the gas cap. I’ve cleaned out the gas tank, gas lines, and the carburetor bowl. The problem seems more acute when the gas tank is full or near full. At this time to alleviate the problem, I blow through the gas cap and the fuel filter fills with gas and it runs good again. But as soon as the fuel filter has no more gas, of course, it stalls until I blow on the gas cap. As the tank gets down to about 1/3 full, the engine runs OK. What else could cause this condition?
ANSWER : I had a similar problem with a sears tractor. close to the carbarator is a rectangle box with a rubber hose going to the engine block – remove the hose and spray carb cleaner in the hose wait a few mins and try again – its a vacuum for the carb

Ryobi gas I changed the primer bulb and gas lines on my machine and now it doesn’t get any gas to the carb. The primer bulb pumps it up, when i take the gas line loose at the brass fitting on the bottom of the carb, gas spews out. If I pour gas straight into the carb, it will start and run until that gas is gone, then it goes dead. It’s like the gas goes to the fitting but won’t go into the carb, even if you pull the trigger like you were running the thing. Any suggestions? Gasless
ANSWER : Check the fuek lines for hole and leaks, check the fuel filter and clean if necessary. remove the carbuerator and inspect the gasket; it should be soft and flexible, if it seems hard or brittle replace it. clean the carb with carb cleaner sray (available at any local auto parts store) and compressed air. make sure you get inside the small fuel rail holes. also check the primer bulb for pin holes and proper seating/seal. if that doesn’t work have the carb repaired at a service center or replaced.

Having problem getting fuel to carb on JD LA 105 lawn tractor with B&S 19.5 gas engine. I replaced fuel filter and fuel pump but gas will not flow to carb. Gas flows from filter to pump and I can pour gas in line to carb and engine will run until gas runs out of line but gas will not flow through pump. Could new pump be bad , if so how can I check it out?

Do you mix gas and oil in this trimmer – Ryobi 30 Cubic Centimeter Curved Shaft Gas Trimmer
ANSWER : Yes. Verifythe ratio, either 40:1 or 50:1

Ryobi weedeater runs good but when shut down fuel drips out carb. ??
ANSWER : You will probably have to remove the carburetor so you can evenly tighten the screws on the ends. If it still leaks, then you will need to get a rebuild kit for it.

Need gas mix solution – Craftsman 25cc 2-Cycle Gas Blower/Vac
ANSWER : Check age of gas. Cannot be more than 30 days old.

Make sure to use fresh gas w/synthetic 2-cycle oil @ 40:1 ratio
(1 gal.) Gas to 3.2 oz. Oil).Do not use old or stale oil/gas mixture. Always
use the proper oil/gas mix. If you do not, your engine will suffer rapid,
permanent damage.

Need to know what carb screw adjustment need to be set at weedeater starts for about 4-7 sec then shuts down put new hoses on checked gas filter and cap checked out ok. i pump the ball about 10 times ,pull cord &starts for about 4-7 sec then shuts down,like no gas or electrical problem. i played with the screw settings & dont know where they shoould be set at . had carb all apart ,put in new plug doesnt seem to matter what i do it does the same thing . any thoughts?also when it starts the motor will rev up when u hit the gas and when it shuts down the gas hose from the tank is still full of gas
ANSWER : If there is a choke adjustment you should set that at full until the trimmer warms up, don’t touch the gas. Then repull start at half choke, don’t touch the gas either at this time. Then start at no choke, and then set your idle on the carberator with the adjustment screw. Also don’t push the primer bulb so many time you will cause the spark plug to get flooded and drown out the spark, which is exactly what is happening.