e connected hit each other. do i have 1 of the springs wrong? blower is on a husqvarna 2246ls with electric clutch. this causong belt damage and frustration. please help.
Agri – Fab Snow Blower – 42″
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Cables do stretch over time. Performing these adjustments will tighten any slack that may have occurred due to stretching. It may be necessary to inspect and possibly replace one or both belts. These belts operate the drive systems for the wheels and the auger.
The serpentine belt need constant tension on the belt to keep it from coming off. If the belt alignment is not aligned then the belt may come off. The tensioner may be out of alignment and not putting enough tension on the belt. Have a mechanic check the tensioner and replace it if needed.
When the auger looses some drive, or slips under load, an adjustment can be made to tighten the auger drive belt. The auger engaging cable has a spring on the bottom end. Remove the belt cover to expose this spring. Perform this adjustment by moving the spring up a notch.
When the auger looses some drive, or slips under load, an adjustment can be made to tighten the auger drive belt. The auger engaging cable has a spring on the bottom end. Remove the belt cover to expose this spring. Perform this adjustment by moving the spring up a notch.
It`s quite simple, really: your car cannot run at all without a timing belt. If the belt breaks while you are on the road, the car will break down immediately – and your engine can experience severe damage.
95% of the time, frequent alternator or serpentine belt breakage is caused by either faulty pulley`s or misaligned or un-properly adjusted belts.
95% of the time, frequent alternator or serpentine belt breakage is caused by either faulty pulley`s or misaligned or un-properly adjusted belts.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Blower belt comes off front pulley causing it to twist on rear pulley. i also think thrre is a problem with my springs, the bolts where they are connected hit each other. do i have 1 of the springs wrong? blower is on a husqvarna 2246ls with electric clutch. this causong belt damage and frustration. please help.
Blower starts but shuts off when I close choke.
ANSWER : Hithere is a fuel delivery problem to find and fix
My 125 bt blower does not reach full power sometimes (intermentent) I changed the plug and the air filter and still the problem persists, it’s only 9 month old
ANSWER : You can try turning the high screw out just a little if that does not work try turning it in some
I have a Toro 51598 electric leaf blower. Last year a breaker in the electrical box tripped and the blower naturally stopped. But, the episode seemed to have damaged the variable-air-flow-dial which on the blower – it was either on or off, nothing inbetween worked. This year, after some solid hours of operation, it just stopped working regardless of where where the variable-air-flow-dial was set. It is worth replacing that variable-air-flow-dial and some related components, or is there likely something else wrong with it? The bushings seem fine.
ANSWER : These machines are considered “disposable” items and most service centers won’t even repair them, saying that it is not “cost effective.” I have never come across a parts list for one other than maybe the plastic housing on them (they may exist), but costwise you may be better off getting another tool unless the Toro is still under warranty.
Husqvarna problems My Husqvarna Backpack Leaf Blower 580 Bfs has about 20 hours on it before it burnt a hole in the top of the piston. Overheated badly and even melted the carb insulator. Is there a known problem with this model?
ANSWER : Call Husqvarna about a possible recall, ore requst warranty service for your unit.
I have a Husqvarna 130 BT will not start; spark plug gap is proper; gas mixture is proper; filter is clean and the engine is getting gas and spark; help
ANSWER : Pull your muffler and see if it starts,if not you are looking to more serious problems like crank seals or loose flywheel causing timing to be off
My blower will not run at all it has spark but will not fire up tried started fluid still nothing not sure what it could be do you know what the compression is suppose to be. maybe rings are fried
ANSWER : Approx 60psi minimum. is your plug wet? or dry
Husqvarna Hand held blower. Model # 125-B No Spark
ANSWER : Husqvarna model 125b weed trimmer what spark plug do i use manual says rcj-6y in technical data and rcj-8y in monthly maint. ????