John Deere

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

It could be your bearings and your spindle pockets, or spindles, have seized up,” says Oshel. If the blades are stuck, pump some grease into the fitting and carefully work the blades back and forth by hand until they move freely.
Worn or broken blade drive belt – If the riding mower blades are not spinning, the blade drive belt may be worn or broken and unable to engage the blades. If the belt is intact, inspect it to see if it`s loose or slipping on the pulleys then replace it with a new one if necessary.
The engine powers both the wheels and the blade, just like a walk-behind self-propelled mower. But instead of being directly connected to it by an axle, the blade on most riding mowers is powered by a belt connected to the engine.
Power take-off (PTO) clutches provide a mechanical disconnect between the power created by gas and diesel engines or electric motors to another piece of equipment. The PTO clutches enable the transmission of that energy to auxiliary equipment that does not generate its own power.
Features. 3 Blades Required for 48″ Cut.
John Deere X300 Pricing

Pricing on the John Deere X300 Series Lawn Tractors ranges from $3,799 to $7,499. They`re available exclusively from John Deere dealers or through Deere.com.

If your John Deere won`t crank and all you hear are clicking sounds when you turn the key, you likely have a bad battery or a bad connection somewhere between the battery and the starter. Double check that the alternator and battery connections are clean and tight.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Cannot remove mower blade pulley nut – John Deere 22HP VTwin 48" Riding Mower
ANSWER : I think its a left hand thread, you undo it clockwise (the “wrong” way)

Read Full Q/A … : John Deere

My john deere z425 start fine but does not move
ANSWER : Check drive pulleys and belts.

Read Full Q/A … : John Deere

L110 bagger installation
ANSWER : I can’t help you on the bagger hole location. But you will need quality hi-lift blades. “Gator-Blades” are some of the best. At www.mowpart.com or Amazon.com

Read Full Q/A … : John Deere

I am trying to find a new or second-hand bonnet for my john deer stx38. i live in the gippsland area. any suggestions?
ANSWER : I use www.greenpartstore.com

Read Full Q/A … : John Deere

I have arx75 rining mower when i put it in gear it does not move when i raise the rearend up in the air the tire spin what could be wrong with it
ANSWER : Http://www.fixya.com/support/t9023324-replaced_transmission_john

Read Full Q/A … : John Deere

How do i replace a clutch on a JD 3020 tractor
ANSWER : Break it in half, then get with it.

Read Full Q/A … : John Deere

John deere stx 30 pto wont engage
ANSWER : Check your fuse or for a broken wire( or shorted)

Read Full Q/A … : John Deere

Mowerdeck will not engage… – John Deere 195HP Hydrostatic 42" Cut Riding Mower
ANSWER : I own a similiar John Deere model (L130, 23HP with a 48″ deck). I would check the electric clutch (called a PTO). To do this check the wires to this clutch and look for something disconnected. These wires (to this PTO clutch) should have twelve volts with the key on and the blades engaged.

Read Full Q/A … : John Deere