Black and Decker GK1640T Worked well then after topping up oil (too much) motor works but chain does not engage

If too much oil is being applied to the chain and bar, it could pick up debris more easily, which could make the chainsaw cut less efficiently and also pose a safety risk as the debris is more likely to fly off the chainsaw at any time.

One tell-tale sign that a chainsaw has flooded is the smell of fresh petrol near the muffler. To ascertain whether this is indeed the problem, simply disassemble the part, pull the starter cord as if you were switching on the engine, then dry it, reassemble it and try switching it on again.

The most common reasons why your automatic oiler isn`t working are: Your chainsaw`s oil tank is empty. The chainsaw oiler is clogged. The oil pump is broken.

The most common reasons why your automatic oiler isn`t working are: Your chainsaw`s oil tank is empty. The chainsaw oiler is clogged. The oil pump is broken.

Without lubricant, the speed at which the chain moves over the chainsaw bar can cause some serious friction. A slowed-down chain and excessive fuel burning mean there`s a lot of friction between your bar and chain, which means a lot of heat is being produced that could do major damage to your saw.

Contact With The Ground

With a single contact with the ground while running, a chainsaw can become very dull. This is because the ground contains sand and dust which is abrasive and contains a lot of tiny rocks. To avoid such occurrences, avoid cutting wood placed on the ground.

Contact With The Ground

With a single contact with the ground while running, a chainsaw can become very dull. This is because the ground contains sand and dust which is abrasive and contains a lot of tiny rocks. To avoid such occurrences, avoid cutting wood placed on the ground.

The chain saw should be oiled before each cut. Manual Oiling System: Lubricate the saw chain by pressing the bulb on the oil reservoir cap twice before making each cut. Hold the bulb down for 3-4 seconds on each press.