Lawn Tractor 48″ Deck, 23 Hp, Model# Yth2348

Experienced gardeners share their insights in answering this question :
Check the USERS Manual

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

When using the bagging feature on rear bag mowers you must remove the mulch plate from the back of the mower. If the mulch plate is still inserted then the grass will not be able to go into the bag.
Very often, a bad or blunt blade is the root cause of bagging issues. Sharpening or replacing a worn blade will improve bagging performance. If you need more help, check out the “Blade sharpening video.” The sharpening video covers safely sharpening the blade both on and off the mower.
If all blades are rotating at the same time, there is no issue with the cutting deck belt that is connecting the blades. If one, or more, blades are not rotating, the cutting deck belt is worn out and needs to be replaced. This should be done by an authorised dealer.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
The reasons why mower is not moving forward or reverse is that the battery is dead, or due to clogged fuel line. Additionally, malfunctioning transmission, or a broken drive belt, also a faulty spark plug, even when friction wheel isn`t in contact with the friction plate, or damaged Tires.
The answer is yes! It`s possible to use your lawn mower without a bag because clippings will decompose when left in the yard and provide necessary nutrients like potassium, phosphorus, or nitrogen for the lawn.
If the PTO clutch is not getting power, if the clutch solenoid is defective, or if the clutch is worn out, the lawn mower blades will not engage. The PTO clutch is not repairable—if the clutch is defective, you must replace it.
If the PTO clutch is not receiving power, the clutch solenoid is defective, or the clutch itself is worn out, the blades will not engage. Since a PTO clutch is not repairable, you will need to replace a broken or worn out clutch with a new one.
A bypass lever is located on the back of the frame, pull out on the lever to move the mower and push it back in before mowing.
Turf plants growing in soil that is too wet can suffer from a lack of oxygen which leads to the death of the roots and a loss of vigor in the plant. When you water well beyond your lawn`s needs, essentially, you are drowning it. This could cause your lawn to eventually die and for grass coming up in clumps as a result.
Don`t bag or mulch.

This helps prevent contamination due to the wet grass. After mowing, make sure you clean under the mower deck and the blade to prevent clumps or clippings from sticking and causing mold down the line.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Bagger support bar does not fit my yth2348 mower. tried several supports and nothing fix.
ANSWER : Check the USERS Manual

Bosch electric lawn mower wont start, how do I fix it?
ANSWER : Cable damaged …renew cable . ..if does not work try condenser.

Lawn mower cranck but wont start…
ANSWER : Since you already checked for spark and air I would drain all the fuel out of it and check that fuel for water. Over time some lawn mowers end up with contaminated fuel. You can see the water sitting on the bottom of the fuel if you let it stand for a bit in a small plastic bowl.

Be sure to empty and dry out you fuel can as well. Especially if the mower stopped running right after a refuel. Which is a good sign your gas can is contaminated too.

I have had a poulan pro 550 series push mower for almost 1 year at the end of the season last year the mower would start briefly and then stop. i have cleaned out the air filter and that did not help.the mower started, i made one revolution around the yard 3/4th of the way the mower quit. I then primed the mower it started then quit and now it will not start at all. Does anyone have any suggestions of what to do. Thanks
ANSWER : There is a little spring that works the carburetor arm. If that popped off then the mower will not run.

I have a Poulan push mower that after mowing in a ditch started making a loud noise and running rough. It almost sounded as if metal was hitting metal. The mower was vibrating more than normal. I checked under the mower and nothing is hitting. After a few times of stopping the mower engine because it sound as if it is going to die down the mower will not start now. The shaft does not appear bent and the blade appears ok. The mower has oil, a good spark plug and a clean air filter. It was running fine until that moment. I did not see anything that I hit but it is possible I hit something in the ditch like a pine cone or branch. What could the problem be and how would I go about fixing it?
ANSWER : If you are sure the oil level is correct then it sounds like it’s about to die, unfortunately. A pine cone shouldn’t cause any damage, but a large branch may do so. Was it smoking before you shut it down? The vibration could be caused from a bent blade. It could also be caused from a part breaking in the motor. I wish I could have given you better news!

Good Luck,

Jim

How do I raise and lower the blade – Toro Super Recycler Super Bagger Lawn Mower Rear Bagger 5
ANSWER : Each wheel has an adjuster on it Usually A is lowest setting and E is highest setting

How to unlock motor on husquavarna mower – Husqvarna Lawn Tractor 48" Deck, 23 Hp, Model# Yth2348
ANSWER : I’d love to help but don’t know what you mean by ‘unlocking’ the motor?
Jurgen

Hello

I have a black and decker lawn mower which is electric and it suddenly stopped working. I checked the power cord and it seems to be fine. When I try to start the lawn mower, I hear the click sound but the mower does not start

Any ideas or suggestions is highly appreciated.

Thanks

T

ANSWER : Took the mower to the Black and Decker warehouse where they replaced the switch in the handle. It cost $53.73 total.