John Deere
Experienced gardeners share their insights in answering this question :
22 psi front, 20 psi rear
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Tire size selection
Choose tires that are large enough to carry the total ballasted weight of the tractor with inflation pressures in the 6 to 14 psi range (lower is better).
The rear tire pressure should be around 12 lbs. That may sound strange if you are not familiar with rear tractor tires but the pressures are nearly always low.
Tire changers often times inflate tire to 35 psi to set the tire beads on the rim. Again, the pressure must be reduced to match the load on the axle. SAFETY WARNING: Never exceed 35 psi when mounting.
The 1025R hosts a three-cylinder Yanmar® TNV Series diesel engine that provides 24.2 gross engine power and 18 PTO horsepower. On the other hand, the 1026R provides operators with 25.2 horsepower. Both engines were designed with performance and durability at top of mind.
This front tractor tire is size 600 – 16. This is a tractor tire only. With a maximum inflation pressure of 68 psi and load capacity of 1360 lbs.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
How do i replace a clutch on a JD 3020 tractor
ANSWER : Break it in half, then get with it.
Read Full Q/A … : John Deere
Looking for information on a John Deere tractor S/N CH0850S017329 and the current estimated value of this tractor with approximately 2,700 hours on it.
ANSWER : Can you please post the model number of the tractor? Thanks
Read Full Q/A … : John Deere
My 1979 111 john deere lawn tractor deck blades shut off
ANSWER : If it has a clutch, that would be the problem. An electric clutch will kick on and off when it is hot if it is bad.
Read Full Q/A … : John Deere
Which way do i install thermatate in john deere 4020
ANSWER : Looking at stat top part looks like a handle around it
Read Full Q/A … : John Deere
HAVE A JOHN DEERE 318 LAWN TRACTOR, CHANGED POINTS AND CONDENSER, WON’T TURN OVER, TRIED STARTING FLUID IN CARB AND NOTHING. CAN IT BE THE COIL AND HOW DO I CHECK? THANKS
ANSWER : Check the coil impedance on the primary and secondary side. You’ll have to disconnect the battery negative cable so you don’t short something out. Unplug the spark plug wires and the two sets of smaller wires connected to the primary side of the coil. The primary coil reading should be between 3.7 ohms and 4.6 ohms while the secondary (spark plug side) should be between 34.2 k-ohms and 41.6 k-ohms. If the resistance values you measure are outside of these ranges, you need to replace the coil.
Read Full Q/A … : John Deere
My tractor is turned to the right and the steering wheel will not let me turn it to the left. What is it?
ANSWER : Usually a frozen kinkgpin or bent linkage.
Read Full Q/A … : John Deere
My Tractor (425) won't start – John Deere 420,1020,2010,2020,2510,2520 Tractor Float
ANSWER : If you have no spark the first thing to replace the time delay module on the left rear side of engine. Its black and about 2 inches by 1 inch with yellow,red,orange and black wires going to it. Replacement is round shaped with same amount of wires.If no fuel to carb check for flow at filter, if theres flow but no pressure look for a split fuel line in tank between pump and sender.
Read Full Q/A … : John Deere
Turned pto off when finished mowing then turned it back on and it does not come on
ANSWER : Check the wiring to the PTO first. if it is good either the PTO or its inline fuse has failed. try the fuse first as it is much cheaper. if it just blows again you are back to replacing the PTO.
Read Full Q/A … : John Deere
