; mower starts fine, but wheels aren’t engaging; can’t figure out what the problem is!! Help!!
Garden

Experienced gardeners share their insights in answering this question :
Has your drive belt come off? Did you lose the shear pin out of one of the drive pulleys?

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

If your John Deere won`t crank and all you hear are clicking sounds when you turn the key, you likely have a bad battery or a bad connection somewhere between the battery and the starter. Double check that the alternator and battery connections are clean and tight.
The likely cause is a failed wheel bearing unless something exceptional has caused the brake caliper to lock the brake rotor. By far, the most common cause of what you are describing is simply bearing failure though. Repair can be obtained by requesting wheel bearing replacement.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Toro 149cc Lawn Mower Won't Start – Toro Lawn Mower With Toro Power Tools
ANSWER : Bad carburetor your old fuel jammed up the jet so it won’t get fuel and if it does it will start and shut off So replace the carb or try to clean the jet and run non oxy fuel only

Read Full Q/A … : Garden

Mower won’t start
ANSWER : This may sound stupid but don’t mean it to…
Have you tried with the choke all the way open? Do you have an automatic cruise? Is the right (correct) pedal being pushed in? These will affect if it starts or not. Also if your drive belt or one of the other belts not being tight enough will affect if it starts or just turns over. Not too many things can stope it from starting with new/good battery AND if its getting gas. Try cleaning your gas line and obviously making sure there is no obstruction around or near your blade, if it does start with blade engaged that is :))
If it doesn’t start with blade engaged, well make sure it’s in neutral. Mine won’t start in reverse but will in forward or neutral.

Hope it helps.

Anthony

Read Full Q/A … : Garden

My toro 6.5 hp push mower (2010), has no fire to the plug. I have not abused it. i have a small yard and it just gets normal use. Now it won’t fire. I first changed the fuel and cleaned the carb thinking it was that crappy ethanol again. but i grounded out the spark plug and cranked it…no spark. I think it has to do with the lever you pull back to start it . they have some stupid complicated safety contraption that rides along the fly wheel when you pull back on the handle for starting and shutting off the engine. …it looks worn out already…like a mini brake pad. any ideas?…do i really have to replace this garbage every year or am i on the wrong path here?
ANSWER : Unhook your wire from the coil that goes to shut off mechanism, and see if you have spark then. the wire may be grounded out, or your coil might have took a ****

Read Full Q/A … : Garden

Diagnosing possible pto issue – Toro Zero Turn Rider 74366 Lawn Mower Tractor Rider Ztr
ANSWER : Check plug on the pto itself.located under the mower near the rear end. contacts probably have dried dirt and mud. if that don’t work, tap it with a hammer,it may be just stuck.Thats what I did and it been working ever since. Hope this helps someone.Let me know.

Read Full Q/A … : Garden

My mower will start but won't stay running – Toro LX466 22HP Lawn Tractor 13RT61RH244
ANSWER : I am going to respond 2 times to this post. The first reply will be generic things to check.
First off check the oil level and make sure it is serviced to full.
If your having a lack of fuel (runing lean) you will need to check fuel flow at the carb fuel mainfold. It should fill a spray paint can lid in less than 10 seconds but teting flow rated of the main fuel line. If you have poor flow here… you need to check the fuel filter and the fuel tank outlet port for obstructions.

Good Fuel flow still shutting off…. remove the carb float bow and clean the debris from the bow’ and the treaded area where the fuel solenoid mounts Additionally you will have to again remove the main fuel line and spray carb cleaner in the float needle area to flush out any debris through the fuel hose connection.

For the second response I need to know which engine is installed on your mower by MODEL number if you can locate it. (there are 3 engines) At least try to find the engine model number. If you can not locate it Brand and HP of the engine (I assume 22 hp) Thanks for choosing FixYa,
Kelly

Read Full Q/A … : Garden

I have trouble starting a toro walk behind mower
ANSWER : All, I thought my carb was shot, so I replaced it. Still, start but no run (and had to use starting fluid). THEN!!! I noticed the spring to the “rev limiter” (just below and towards rear of carb) was not “tight”. The stupid bracket that holds the end of that spring had been bent down ~1/16″ and that caused all this heartache. CHECK YOUR REV LIMITER!!!

Read Full Q/A … : Garden

<!– from fixya rte –>Rj19lm plug gap for a 195cc 4cyl lawnboy – Lawn-Boy lawnboy" Mower Blade 21"
ANSWER : As a starting point in my shop i always use 0.30 in. For all my mowers

Read Full Q/A … : Garden

My dls 3500 mower will not start at all, I charged the battery but the engine wont even turn. All the wiring and fuses seem to be ok
ANSWER : I had the same problem. I replaced the wiring harness for a short fix, corrosion in the terminals that connect to ignition switch. This worked for a while. Then replaced ignition switch this also worked for short time. Now I just open the hood to reach behind the ignition switch and wiggle wires while turning key to start until it starts keep wiggling to get good contact. If it won’t stop after it starts, wiggle wires after you turn the key to off. It will stop.

Read Full Q/A … : Garden