Hozelock
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
A: The most likely cause is grit or dirt in the on/off control. In which case dismantle the on/off control, clean thoroughly and replace. If the spray fails to shut immediately and continues to dribble out it could be due to air being trapped in the lance.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
How do you refill?
ANSWER : Remove all pressure by keeping the hose open until no pressure is left. place pump handle down toward tank. Turn count counter clock wise to unscrew. Take assembly out of tank then fill tank. Reinstall in reverse order.
https://www.chapinmfg.com/sprayers
Read Full Q/A … : Hozelock
How do you get the top off a Roundup 2 gal. sprayer?
ANSWER : Release the pressure, push the handle down andturn it to the left.
Read Full Q/A … : Hozelock
Won't seal and hold pressure – Ace Hardware Acer Spray and Go Sprayer
ANSWER : Try smearing some Vaseline on the gasket that goes around the pump shaft at the top.
Read Full Q/A … : Hozelock
Sprayer looses pressure pump issue ?
ANSWER : You can take the intake part of the pump apart and clean/lube the diaphragm of the pump. If you didn’t clean it out last time it was used there will be residual or cake built up. Make sure the down snorkel is clear and doesn’t have any contamination in the tube. Check the screen/filter also.
Read Full Q/A … : Hozelock
486 Sprayer, lost instructions, sprayer lable washed off
ANSWER : See if this helps:
http://www.gotosprayer.com/sprayers/hose-end-sprayers/gilmour-dial-a-mix-hose-end-486
Read Full Q/A … : Hozelock
Trying to remove pressure tank from inside spray unit.
trying to replace all seals.
ANSWER : Dont !!!!! just buy a new one bout 100 bucks but if u want it comes out thru top but u have to take lose underneath
way too labor intensive for the price of new one
way too labor intensive for the price of new one
Read Full Q/A … : Hozelock
I have no pressure in my flo-master sprayer after pumping
ANSWER : Make sure the tank pressure release is shut, or make sure the rubber o-ring under the pump is there. You should feel back pressure after a few pumps.
Read Full Q/A … : Hozelock
Assembly instructions for Palm springs 10 x20
ANSWER : Palm Springs 10’x30′ (3m x9M) party tent set up instructions.Hope this helps.
Read Full Q/A … : Hozelock
