15″ Electric Factory Reconditioned Trimmer (ZRRY41002) -…

Hand drill battery won’t hold charge. Can I replace? Where? What price?
Experienced gardeners share their insights in answering this question :
Yepp, you can replace it..BUT…its more expensiv to buy a new battery then it is to buy a new hand drill…almost.
If you want to replace it i sugest you go to the store where you bought your hand drill and buy one there.

Good luck to you
Nic

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

One significant reason why a car battery won`t hold a charge is age. Obvious signs that your battery is too old and worn out include corrosion and cracking. If it`s at least four years old, then it should probably be replaced. For younger batteries, a car that isn`t started for days or weeks can also lose its charge.
It`s easy: mix and dissolve Epsom salt and distilled water in the proportion 1/3. The issue can be resolved by adding the solution to the battery cells at the battery terminal until the plates are covered by 1/4 to 1/2.
Your alternator is to blame

If you jump the battery and it only remains charged for a little while, that`s a positive sign of a faulty alternator. However, it`s very important to have your car thoroughly inspected before you replace anything.

You may charge your 12-volt battery by connecting the BLACK negative wire from your charger to the negative terminal of your 12-volt battery. This will get you connected to the charger. When connecting to the terminal, you must make use of the clips or clamps provided.
Car batteries die when they weaken from too much cold, heat, drain, corrosion or vibration that they don`t have enough electrical power to crank the engine. No matter how tough they look, car batteries are sensitive electrochemical devices.
All is not lost because you can revive them. If you have a balance charger designed for charging LiPo batteries, chances are it will revive your lithium-ion cells too. Or, if you have a digital multicharger that has `revive` functionality, that will work too.
The only method to start an automatic car with a dead battery is to use a portable battery charger. If you drive an automatic car, make sure you have a simple portable charger in your roadside emergency toolkit.
This could be due to a faulty alternator, a bad connection, or a problem with the battery itself. If your Jump start doesn`t work, a third reason could be because there is a problem with the starter motor. The starter motor is responsible for turning the engine over when you turn the key in the ignition.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Ryobi troubleshooting Recently bought the two set package of 18V lithium batteries however the tool will not work. It was working however it has stopped . Tried two different batterie , both fully charged ,with no results.
ANSWER : The motor may have overheated and burned open. Use a multimeter to check resistance across the battery contacts in the tool with the switch closed. If it reads open, the motor has failed.

12 volt re-chargeable battery won’t hold charge
ANSWER : Yepp, you can replace it..BUT…its more expensiv to buy a new battery then it is to buy a new hand drill…almost.
If you want to replace it i sugest you go to the store where you bought your hand drill and buy one there.

Good luck to you
Nic

Battery will not charge red light steady and then blinks?
ANSWER : Sorry but you will need new batteries.

Where is the charger location on the snipper? Cant seem to find where to plug it in–see nothing but screws but no receptacle
ANSWER : The battery probably is removed and placed in a separate charging dock.

Battery not charging. Light on charger is red for charge…it’s plugged in properly?????
ANSWER : Battery is bad.

Battery?, wiring?? Had a recent problem with blades not engaging. I have had also had a slightly older issue of battery not holding charge so i have to boost or jump start mower. I went out and bought brand new battery and after one usage it would not hold charge and blades will still not engage. Would the issue related to the battery effect the engagement of the blades???
ANSWER : If your Alternator didn’t charging the battery, even though you brand new battery will not last. So there is two possible cause, 1) Your Alternator is not functioning. 2) there is a wiring problem that causing your battery to discharge easily, but you check it after you switch off the key remove the battery negative terminal then touch it back to batt term. and see if there is little blue spark, if does your wiring system got problem. If not, so your Alternator do not charge the battery.

Bought trimmer last year…battery no good this year…will not charge
ANSWER : Check that your charges is working – charge light on the unit or test output voltage. If these are ok, you will have to buy a new power pack for your trimmer or get a battery specialist to make up one for you. This will be by far the cheaper option.

The battery is not charging. I am getting a red blinking light.
ANSWER : That is the typical issue of dell batteries, They called back for several times.